Loading…
16
My old foreman told me to never trust a 'good enough' finish pass on aluminum
He said it would always show tool marks under the right light, and I thought he was just being picky (you know, one of those 'back in my day' guys). So on a job for a local brewery's tap handles, I ran the final pass at 0.005" like I always did, figuring it was fine. Got the parts back from anodizing, and under their bright bar lights, every single one had these faint swirls that looked awful. Had to eat the cost and re-run all 50 pieces at 0.002" like he said. Anyone have a go-to finish pass depth for 6061 they swear by?
3 comments
Log in to join the discussion
Log In3 Comments
wilson.anthony5mo ago
Sounds about right, learned that one the hard way too.
7
williamprice5mo ago
Wait, you actually paid $200 for that, @wilson.anthony?
2
the_logan4mo ago
What did you think you were actually getting for that price?
10