Hot take: I sped my finish pass up 20% and the chatter got quieter
Running a 3/4 inch end mill in 6061 on a Haas VF2 and I always babied the finish pass at 40 ipm. Boss told me to bump it to 48 to save a few parts on a run of 60 brackets, and I figured I'd be re-cutting the whole batch. Instead the chatter mostly went away and the finish came out smoother than my old numbers, so I was basically fighting myself with too slow a feed. My guess is I was rubbing instead of cutting, but I only ran the one job so far. Anyone got a rule for how far you can push that before it turns on you?