Why does nobody mention that cheap 2 flute end mills walk all over the place in aluminum
I've been running a little benchtop router table setup in my garage for about 8 months now and I kept wondering why my aluminum brackets had this ugly chatter and the edges looked chewed up. I figured it was my feeds and speeds, so I messed with those for like 3 weekends straight, tried slower rpm, faster rpm, lighter cuts, nothing helped. Then a machinist buddy came over to look at my scrap pile and pointed at my $3 Amazon end mills and just laughed. He said the cheap ones have uneven flute geometry and they grab instead of slicing, so they pull the tool off the wall and that's where the chatter comes from. Swapped in a real 2 flute carbide bit and the exact same program cut clean on the first try, no other changes. I wasted probably $40 in aluminum bar stock and a whole month chasing the wrong thing. Has anyone else got burned by cheap cutters before they figured out it was the tool and not the machine?