A lead tech told me to stop troubleshooting with the meter and I fought him on it for a month
Six months ago I was chasing an intermittent APU fault on a Challenger 300 for three days, swapping LRUs and ringing out harnesses with a Fluke, getting nowhere. The lead tech watched me for about ten minutes and said, "you keep testing the wire, test the pin." I blew him off at first because I have been doing this for nine years and my meter work is solid. Turns out the connector pin had a worn crimp that only lost contact when the rack got warm, so the wire itself tested fine every single time. Now I do a pin drag test and a close look at the crimp before I ever grab the meter, and that APU fault has not come back in four months. Cost me about $40 for a cheap set of pin gauges and probably saved me a whole shift of guessing. Anybody else had a lead tech call out a habit you did not want to hear about?