My spindle bearings went from screaming to silent in 2 weeks and I still dont get why
So my old Bridgeport clone started making this awful high pitch whine back in April, loud enough that I had to put ear muffs on just to run a simple facing pass. I figured the spindle bearings were shot and I was looking at a $400 rebuild, so I kept running it because I had a batch of 40 aluminum brackets due for a guy in Mesa. About 2 weeks later the noise just went away on its own and the finish on my parts got way better too, went from visible chatter marks to almost mirror on the last 10 or so. Only thing I changed was I switched from a heavy grease to a lighter spindle oil on the lube points and started letting it warm up for 5 minutes before taking a cut instead of going straight into it cold. My buddy who runs a lathe shop says the bearings were probably just dry and the warm up let them seat right, but I cant figure out if I actually fixed something or if its just hiding a problem that will come back. Anyone ever have a machine quiet down on its own like that and did it stay quiet or bite you later?