Hot take: I stopped drawing to layout lines and started cutting from the model, my scrap pile dropped by half
I ran parts the old way for about six years, marking every hole with a pencil and a combo square, then center punching and hoping the drill walked less than a sixteenth. Back in March I had a job for a guy in Akron, 40 brackets out of 6061, and I was staring at a pile of scrapped ones on the floor wondering why I was still doing it that way. So I started clamping stock and letting the DRO and the cutter find the location instead of my eyes and a sharpie. My scrap went from maybe 5 parts a run down to 2, and honestly the tolerance callouts stopped scaring me. It sounds dumb now but I kept thinking layout was the careful way, like the pencil line was some kind of safety net. Turns out the line was just where I was allowed to be wrong. What got you off laying stuff out by hand, if you ever did?