Guy running the lathe next to me asked why I still dial in every blank by hand instead of using the stops, and it got under my skin | Cnc Fabrication - Librear
Guy running the lathe next to me asked why I still dial in every blank by hand instead of using the stops, and it got under my skin
He's been doing this 20 years and said "the indicator is lying to you half the time anyway, trust the stop." I've had the same 0.003" taper on my finish cuts for two weeks and never thought to check my tailstock alignment until he said it. Now I'm second guessing whether I've been chasing the wrong problem the whole time, anyone else run into this?
Had a 0.0025 taper on 4140 shafts for a solid month and blamed the tool, the speeds, my chuck, all of it. Turns out my tailstock was off by about a thou over 8 inches and I never even put an indicator on it. What got me was that the guy told me the same thing, trust the stop, and I brushed him off because he's grumpy and loud. He was right and I wasted a month. Your finish cut taper showing up the same way every time is a real tell, so check the tailstock before you chase anything else. Take it from someone who learned the slow way.